Cable joint waterproofing steps

1. After the terminal is crimped, wrap the waterproof packing around the terminal and shrink the heat shrinkable tube.

2. If it is a slightly humid environment, wrap the waterproof packing tape on both ends of the cable and shrink the sheath tube (the two ends of the sheath tube must be glued).

3. If the environment is bad, you must use self-adhesive waterproof tape to strengthen the waterproof (you can also use heat-shrinkable waterproof tape, we generally use self-adhesive tape, heat shrink tape is used for cable damage repair).

A. After filling the waterproof filling adhesive, wrap the outer layer of the filling rubber with a self-adhesive waterproof tape or stretch the self-adhesive waterproof tape to wrap the multilayer, but the thickness should not be too thick, so as not to cause the insulating sleeve to not enter.

B. Shrink the heat-shrinkable tube in the glue.

C. Wrap the waterproof tape on both ends of the heat-shrinkable tube, then wrap a layer of self-adhesive waterproof tape, wrap the waterproof tape and self-adhesive tape on both ends of the cable insulation sheath, and then heat the shrinkage of the sheath tube.